I believe what should happen is that in 'on' and at that voltage I should see a green light and the compressor should kick in with the fan, with the compressor running at high speed until the fridge gets down to a low temp, when it should switch into economy mode (low compressor speed and no fan). When the engine is charging the batteries and I have 13.8v+ knocking around it does exactly the same in both modes. If I switch to Freeze the red freeze LED comes on, the fan comes on, and the compressor runs (but no noticeable noise increase which I would expect with it supposed to be running at a higher rate, and eventually (after several hours) the collector plate gets to a level of cold that I would expect. But it sucks about 5 amps continuous.Äownload Comprehensive Meta Analysis Keygen. On battery power I can switch the ASU (the old type - 3 LED's and a switch) between On and Freeze, but on 'On' no green LED comes on, only the yellow 'economy' LED, the fan does not run, but the compressor does seem to run and the fridge gets cold'ish. The new (to me) Beneteau 325 has an Isotherm 3000/3500 fridge, circa mid 90's.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |